AudioNormalizationSettings

Advanced audio normalization settings. Ignore these settings unless you need to comply with a loudness standard.

Types

Link copied to clipboard
class Builder
Link copied to clipboard
object Companion

Properties

Link copied to clipboard

Choose one of the following audio normalization algorithms: ITU-R BS.1770-1: Ungated loudness. A measurement of ungated average loudness for an entire piece of content, suitable for measurement of short-form content under ATSC recommendation A/85. Supports up to 5.1 audio channels. ITU-R BS.1770-2: Gated loudness. A measurement of gated average loudness compliant with the requirements of EBU-R128. Supports up to 5.1 audio channels. ITU-R BS.1770-3: Modified peak. The same loudness measurement algorithm as 1770-2, with an updated true peak measurement. ITU-R BS.1770-4: Higher channel count. Allows for more audio channels than the other algorithms, including configurations such as 7.1.

Link copied to clipboard

When enabled the output audio is corrected using the chosen algorithm. If disabled, the audio will be measured but not adjusted.

Link copied to clipboard

Content measuring above this level will be corrected to the target level. Content measuring below this level will not be corrected.

Link copied to clipboard

If set to LOG, log each output's audio track loudness to a CSV file.

Link copied to clipboard

If set to TRUE_PEAK, calculate and log the TruePeak for each output's audio track loudness.

Link copied to clipboard

When you use Audio normalization, optionally use this setting to specify a target loudness. If you don't specify a value here, the encoder chooses a value for you, based on the algorithm that you choose for Algorithm. If you choose algorithm 1770-1, the encoder will choose -24 LKFS; otherwise, the encoder will choose -23 LKFS.

Link copied to clipboard

Specify the True-peak limiter threshold in decibels relative to full scale (dBFS). The peak inter-audio sample loudness in your output will be limited to the value that you specify, without affecting the overall target LKFS. Enter a value from 0 to -8. Leave blank to use the default value 0.

Functions

Link copied to clipboard
Link copied to clipboard
open operator override fun equals(other: Any?): Boolean
Link copied to clipboard
open override fun hashCode(): Int
Link copied to clipboard
open override fun toString(): String